touchWASD Firmware Flasher
Burn touchWASD firmware to your ESP32-S3 board via browser
Initializing...
ready
Board Type
M5Stack AtomS3
Generic ESP32-S3 Dev Module
Firmware Version
Loading...
Erase all flash before flashing
Flash Firmware
Bootloader Mode Instructions
M5Stack AtomS3
Connect the AtomS3 to your computer via USB-C
Press and
hold
the side button (the only button on the side)
Keep holding for
2 seconds
until the green LED inside turns on
Release the button
The device is now in download mode (green LED indicates bootloader mode)
Click
Flash Firmware
above and select the device in the browser serial prompt
Generic ESP32-S3 Dev Module
Connect the board to your computer via USB
Press and
hold
the
BOOT
button (
GPIO0
)
While holding
BOOT
, press and release the
EN
/
RST
button
Release the
BOOT
button
The device is now in download mode
Click
Flash Firmware
above and select the device in the browser serial prompt